Ground Control 2005-2014 MUSTANG COMPLETE KIT 

THIS KIT INCLUDES THE FOLLOWING:


2 Single adjustable, custom valved Konis in Ground Control short strut housings

Complete Shortened Front Strut Housing - Machined from seamless DOM 1026 steel alloy tubing. Heavy-duty sway bar bracket welded on. Our design is much stronger and more rigid than any of the aftermarket housings that are actually modified stock housings, with skip-welded gussets and and all original brake line and abs tabs retained.


Koni Single Adjustable Front Strut - Struts are externally adjustable from underneath the hood, even with the factory strut brace. This strut is prepared for coil over use, and eliminates machining of critical suspension components.


Ground Control Threaded Sleeves - This system is designed to eliminate stress risers caused by machining notches into the strut housing. Unlike other companies that claim superiority by cutting threads into a critical component of the suspension, Ground Control uses engineering common sense to maximize the strength of the suspension.


Ground Control Adjustable Spring Perch - A unique design, which uses an Allen head bolt to clamp the single threaded perch into the correct position. No secondary pieces are needed to "jam" the threaded perch into position.

2 SHORT Koni single adjustable rear shocks

Koni Single Adjustable Rear Shocks - Preadjusted to match rear spring rates using our shock dyno. The GC sport rear shocks are adjustable from inside the trunk, however the standard sport rear shocks must be removed to be adjusted.

1 Pair front Camber Plates

Ground Control Camber/Caster Plates - Correct camber adjustment at the top of the strut. Caster adjustment, aircraft bearings, engraved with calibrated degrees. Every component is anodized or plated, including fasteners. Adds extra travel to avoid excessive bottoming out, this is a very well engineered product.
Camber and caster are adjustable by sliding the mounts, without removing any components from the car. The priority of this design is to allow repeatable alignment changes which the 2005 Mustang needs.
The Ground Control camber plates feature a bearing and a bushing, which allows for articulation of the shock shaft. The steering bearing is very under stressed, as the Ground Control design does NOT articulate the steering bearing.

4 Ground Control springs, manufactured by Eibach, to GC specs

Eibach Springs - Eibach springs are made on German machines both in the USA and in Germany, however all Eibach springs have a lifetime guarantee against sagging, rate change, or any manufacturing or material failure. Lifetime guarantee. Compare!

2 Ground Control bump stops (made in Germany)

Ground Control Bump Stops - We do not just ask you to reuse your stock bump stop. The stock bump stop is designed for stock suspension we provide a bump stop designed to work with our suspension. These are soft foam, same quality as OE Ford parts, but made to our specs in Germany. Our race bump stops are even different than our street bump stops.

2 Rear Ride Height Adjusters

Ground Control Rear Ride Height Adjustment Kit - Billet aluminum threaded adjusters bolt on top of the rear axle. Height adjustment range is 2 inches.

1 Pair rear upper shock mounts (urethane)

Ground Control Rear Shock Mount - Billet aluminum, urethane bushings, pre-assembled. Includes gaskets and reinforcements.