J's Racing Front Camber Joint S2 Front +3 degree Honda S2000
CAJ-S1-S2
The insufficient negative camber is always a problem for S2000. This product creates enough negative front camber by locating the lower ball joint at an eccentric angle from the center.
These camber joints also corrects the front lower arm position back close to horizontal, so that the correct geometry is restored with the accurately adjusted roll center.
It works in a variety of driving situations from the street to the race track. It is a must-have item for a spirited sport driving with a Honda S2000.
These camber joints also corrects the front lower arm position back close to horizontal, so that the correct geometry is restored with the accurately adjusted roll center.
It works in a variety of driving situations from the street to the race track. It is a must-have item for a spirited sport driving with a Honda S2000.
Was:
$359.00
Sale:
$311.00
Save:
13%
Save:
$48.00
Description
Adjustable range: 3 to 5 degrees
Ride height: Recommended to the vehicle whose height is reduced more than 40mm
Included in the kit:
Camber Joint S1 x2
Clip x2
Castle nut x2
* The stock bolts are to be reused or use new stock ones.
Please apply the correct tightening torque. After the installment, it is necessary to properly adjust the ride height and alignment.
It is highly recommended to check the tightening condition of the bolt & nut periodically. [Always check it before the track event or race]
Ride height: Recommended to the vehicle whose height is reduced more than 40mm
Included in the kit:
Camber Joint S1 x2
Clip x2
Castle nut x2
* The stock bolts are to be reused or use new stock ones.
Please apply the correct tightening torque. After the installment, it is necessary to properly adjust the ride height and alignment.
It is highly recommended to check the tightening condition of the bolt & nut periodically. [Always check it before the track event or race]
Specs
Material : Forged aluminum 6061
The surface is anodized red with a laser carved ‘J’s Racing” seal
Ball joint S45C
Boll stud SCM435 HB195-260, Fluctuation angle 33 degree all around
The front camber angle can be adjusted to the stock + 3 degree
The front roll center value can be adjusted back to the correct one.
The surface is anodized red with a laser carved ‘J’s Racing” seal
Ball joint S45C
Boll stud SCM435 HB195-260, Fluctuation angle 33 degree all around
The front camber angle can be adjusted to the stock + 3 degree
The front roll center value can be adjusted back to the correct one.
Details
- CAJ-S1-S2
- CAJ-S1-S2
- J'S Racing
- New
Categories
Shipping Information
- Item Requires Shipping
- 4.0 lbs.
- W7.0000” x H3.0000” x L12.0000”
- Free FedEx / UPS Ground Shipping!
Customer Reviews
Total Reviews (0)
You must login to post a review.
Write the First Review!